Lead Corrosion Test Apparatus
Constant temperature apparatus rotates copper and lead test panels in
lubricant samples to determine corrosiveness to lead per FTM specifications.
Panels are rotated at 600rpm in samples maintained at 163°C (325°F) and
aerated at 0.94L/min (2.0 Cu. ft./hr).
Test panel shafts ride on ball bearing spindles driven by a 1/15hp motor. A
counterbalanced support bar positions the drive shaft for testing or for
mounting and removal of test panels. When the support bar is raised, a safety
microswitch automatically stops the drive motor to prevent splashing of hot
Fully insulated bath features double-wall stainless steel construction, with
a built-in support rack to suspend test cells vertically at the proper depth.
Microprocessor PID control provides quick temperature stabilization without
overshoot, and the bath is protected by an over-temperature control circuit
that interrupts power should bath temperature exceed a programmed cut-off
point. Dual LED displays provide actual and setpoint temperature values in
°C/°F format. Communications software (RS232, etc.), ramp-to-set and other
enhanced features are available as extra cost options. Contact your Koehler
representative for information. A 1/20hp stirrer thoroughly circulates
the bath medium for temperature uniformity. Redundant over-temperature protection
is provided by a built-in backup thermostat. Flowmeters and valves mounted on
a convenient manifold provide individual air flow control for each test cell.
Conforms to the specifications of: FTM 791-5321.1
Testing Capacity: 6 lubricant samples
Maximum Temperature: 199°C (390°F)
Temperature Control Stability: ±0.05°C (±0.1°F)
Air Flow Control: 0.94 ± 0.047L/min (2 ± 0.1 Cu. ft./hr) six (6) flowmeters
mounted on a common manifold
220-240V 60Hz, Single Phase, 14.5A
220-240V 50Hz, Single Phase, 14.5A
Copper Test Panels (6)
Lead Test Panels (6)
Mounting Hardware for Panels
Net Weight: 214 lbs (97kg)
Shipping Weight: 330 lbs (150kg)
Dimensions: 33.5 Cu. ft.